* levcap-b-040.m -- relieved bottom of lever cap
* use 1/2" diam ball end mill
* oriented bottom up, tip at left
* tip is X=0, bottom surface (up) is Z=0
* y=0 is edge near operator (eventual right)
* This is about .040 cut per pass in bronze
Rapid      Z 0.1
Rapid      Y -0.26
Rapid      X 0.1584 Z -0.0280
Call 1
Rapid      X 0.2017 Z -0.0474
Call 2
Rapid      X 0.2459 Z -0.0647
Call 1
Rapid      X 0.2910 Z -0.0798
Call 2
Rapid      X 0.3367 Z -0.0926
Call 1
Rapid      X 0.3830 Z -0.1031
Call 2
Rapid      X 0.4298 Z -0.1113
Call 1
Rapid      X 0.4770 Z -0.1172
Call 2
Rapid      X 0.5243 Z -0.1207
Call 1
Rapid      X 0.5718 Z -0.1219
Call 2
Rapid      X 0.6193 Z -0.1207
Call 1
Rapid      X 0.6666 Z -0.1172
Call 2
Rapid      X 0.7138 Z -0.1113
Call 1
Rapid      X 0.7606 Z -0.1031
Call 2
Rapid      X 0.8069 Z -0.0926
Call 1
Rapid      X 0.8526 Z -0.0798
Call 2
Rapid      X 0.8977 Z -0.0647
Call 1
Rapid      X 0.9419 Z -0.0474
Call 2
Rapid      X 0.9852 Z -0.0280
Call 1
Rapid      Z 0.1
EndMain
*
Sub 1
Line       Y 2.26 Feed 4.0
EndSub
*
Sub 2
Line       Y -0.26 Feed 4.0
EndSub
