* rside-cr.m - Yehle #13 9" smoothing plane
* Right side plate, held horizontally
* Cuts rear of chamfer on top profile only
* Front of part is toward left
* Part zero is: x=0 at front edge,
*  y = -1.95 is top of side
*  (the edge toward operator)
* Z is plunged to depth you want cut
* (run program once at each depth)
* Tool 14 is 3/8-to-3/4 chamfer mill, 45 degree
Rapid      Y -2.5 Tool# 14
Rapid      X 9.5
Rapid      Y 1.0
Line       X 9.0000 ToolComp Left Feed 20
Line       Y 0.2
Line       Y -0.6613 Feed 3.0
Line       X 6.7616 Y -0.9897
Arc Ccw    X 5.2062 Y -1.9500 Radius 2.3497
* Continue cutting into air for .1" tangent line
Line       X 5.1491 Y -2.0315
Line       Y -2.5 Feed 20.0 ToolComp Off
Line       X 5.2 Tool# 0
* Can just lower cutter and run again, unless
* something is in the way between X=5 and 9.5
