* prsidup2.m - Jim Yehle 14" panel infill plane
* Right side plate, held horizontally
* Cuts middle (unchamfered) part of top profile only
* Front of part is toward left
* Part zero is: x=0 at front edge,
*  y = 0 is at root of dovetail sockets
*   (i.e. top of sole, the edge toward operator)
* Z is plunged to depth you want cut
* (run program once at each depth)
* Tool 14 is 1/2" mill
Rapid      Y -3.5 Tool# 14
* Come in on .5" tangent line to upcoming line
Rapid      X 6.8113
Line       Y -2.9808 ToolComp Left Feed 10
Line       X 6.6777 Y -2.4991 Feed 3
Line       X 6.6541 Y -2.4140
Arc Ccw    X 5.8576 Y -1.9378 Radius 0.6726
Line       X 5.1531 Y -2.0971
Arc Cw     X 4.1316 Y -1.8581 Radius 1.2
Line       X 3.5645 Y -1.3973
Arc Ccw    X 2.8950 Y -1.3677 Radius 0.5625
Line       X 2.6510 Y -1.5325
* Continue cutting into air for .25" on same course
Line       X 2.4438 Y -1.6725 Feed 6
Line       Y -3.5 Feed 20 ToolComp Off
Line       X 3 Tool# 0
* Can just lower cutter and run again, unless
* something is in the way between X=2.5 and 7
* or continue profile with prsidup3.m