* prsidup3.m - Jim Yehle 14" panel infill plane
* Right side plate, held horizontally
* Cuts front part of profile or chamfer only
* Front of part is toward left
* Part zero is: x=0 at front edge,
*  y = 0 is at root of dovetail sockets
*   (i.e. top of sole, the edge toward operator)
* Z is plunged to depth you want cut
* (run program once at each depth)
* Tool 14 is 1/2" mill (or 3/8-to-3/4 chamfer mill, 45 degree
Rapid      Y -3.5 Tool# 14
* Come in on .5" tangent line to upcoming line
Rapid      X 3.0251
Line       Y -1.8642 ToolComp Left Feed 10
Line       X 2.6510 Y -1.5325 Feed 3
Arc Ccw    X 1.7376 Y -0.9316 Radius 2
Arc Ccw    X 0.8732 Y -0.7415 Radius 4
Line       X 0 Y -0.6489
* Cut front (may have been done already)
Line       Y 0
* Continue cutting into air for .25" on same course
Line       Y 0.25 Feed 6
Line       X -0.75 Feed 40
Line       Y -1.5 ToolComp Off
Line       Y -3.5 Tool# 0
* Can just lower cutter and run again, unless
* something is in the way between X=0 and 3
